Go into Settings / General / Accessibility and set Call Routing to Bluetooth Headsetģ. – please note this will delete any paired Bluetooth Devices AND WiFi connections, so make sure you know the WiFi passwords.Ģ. !! Make sure you only delete the Network settings !! Go into Settings / General / Reset Settings / Reset Network The MKi9100 / MKI9200 will then delete all paired devices and re-boot.Īfter it turns on again you will need to set ring volume ( Settings / Ring Volume) and on the MKi9200 you will need to reset “Sound Stage” Audio effects > Sound stage > Settings > Centre (is recommended by JustCarKits)ĭelete all Bluetooth devices on the iPhone – Settings \ Bluetooth \ Phone X, ” Forget this phone “, then confirm. Click on button to enter Settings then go down to Advanced and select “Factory Reset”. When the kit has gone to the home screen press centre button and rotate to Settings. Turn on ignition and wait approx 30 seconds for the kit to turn on. Proceed to Stage 2.įor the MKi9100 and MKi9200 do the following: After it has powered up again, press the centre button to select English (or other language by rotating jog wheel) as the required language. You will hear “Memory Erasing in Progress”, after which the MKi9000 will re-boot. Press and hold for 2 to 3 seconds the RED and GREEN buttons on the remote at the SAME TIME. Reset the Parrot MKi9000/ MKi9100 and MKI9200.
With the recent launch of ios 10, 11 and 12 a few users are reporting an issue where the iphone would work correctly with the Parrot MKi9000 / MKi9100 and MKi9200 when using ios 9, but since the upgrade to ios 10, 11 or 12 the phone connects / disconnects / connects / disconnects.Īndroid and Windows users are not affectedĪpple iOS users are recommended to do the following – revert to IOS 9 ( if only, as this would cure the issue – sadly Apple do not allow this…)Īs an alternative solution please try the following: